Manual

SS
SS
S
tep 4tep 4
tep 4tep 4
tep 4
RR
RR
R
emoemo
emoemo
emo
vv
vv
v
e De D
e De D
e D
ust Sust S
ust Sust S
ust S
hield, and Ihield, and I
hield, and Ihield, and I
hield, and I
nstall Cnstall C
nstall Cnstall C
nstall C
aliper Baliper B
aliper Baliper B
aliper B
racketracket
racketracket
racket
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 [phone]
www.stoptech.com 11
The dust shield must be permanently removed
from each front wheel, to accommodate the
AeroRotors.
Remove the dust shield retaining screws, using
a T-25 Torx wrench, then slide the dust shield off
of the hub.
Install the caliper bracket, using the stock cali-
per mounting bolts, and torque them to
55 lb-55 lb-
55 lb-55 lb-
55 lb-
ftft
ftft
ft, using a 16mm socket.
Remove the Jet nuts and washers from the cali-
per mounting bracket, and put them in a safe
place for later use.
Note: Due to their close proximity to theNote: Due to their close proximity to the
Note: Due to their close proximity to theNote: Due to their close proximity to the
Note: Due to their close proximity to the
hub, an L-shaped wrench may be required tohub, an L-shaped wrench may be required to
hub, an L-shaped wrench may be required tohub, an L-shaped wrench may be required to
hub, an L-shaped wrench may be required to
remove the dust shield retaining screws.remove the dust shield retaining screws.
remove the dust shield retaining screws.remove the dust shield retaining screws.
remove the dust shield retaining screws.