Manual

Step 7Step 7

Step 7

ttach Sttach S

ttach S

tainless Stainless S

tainless S

teel Bteel B

teel B

rake Linerake Line

rake Line

3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799

www.stoptech.com 19

Install the caliper end of the stainless steel brake

line by first placing a copper crush washer on

either side of the banjo fitting, then inserting

the banjo bolt into the caliper.

Note: The orientation of the banjo fittingNote: The orientation of the banjo fitting

Note: The orientation of the banjo fitting

should be as shown in the photograph to theshould be as shown in the photograph to the

should be as shown in the photograph to the

left, with the brake line pointing upward to-left, with the brake line pointing upward to-

left, with the brake line pointing upward to-

warwar

war

d the bleed scrd the bleed scr

d the bleed scr

ewew

Torque the banjo bolt to

apprappr

appr

ximately 14 lb-ximately 14 lb-

ximately 14 lb-

ftft

ft, using a 14mm wrench or socket. Do not use

a torque wrench, as overtightening the bolt can

strip the aluminum threads, causing irreparable

damage to the caliper.

Copper

crush washers

Banjo bolt

Slide the grommet on the stainless brake line

into the bracket on the strut, and apply a cable

tie, as shown in the photograph to the right, to

hold it in place.

Once the grommet is firmly secured, trim the

excess from the cable tie.