Manual
SS
SS
S
tep 2tep 2
tep 2tep 2
tep 2
DD
DD
D
isconnect Sisconnect S
isconnect Sisconnect S
isconnect S
tock Btock B
tock Btock B
tock B
rake Linerake Line
rake Linerake Line
rake Line
3541 Unit A, Lomita Boulevard, Torrance, CA 90505 (310) 325-4799
www.stoptech.com 9
WW
WW
W
arar
arar
ar
ning: Sning: S
ning: Sning: S
ning: S
pilled brpilled br
pilled brpilled br
pilled br
ake fluid will damage most painted surake fluid will damage most painted sur
ake fluid will damage most painted surake fluid will damage most painted sur
ake fluid will damage most painted sur
faces, and shouldfaces, and should
faces, and shouldfaces, and should
faces, and should
be cleaned off be cleaned off
be cleaned off be cleaned off
be cleaned off
immediatelyimmediately
immediatelyimmediately
immediately
. T. T
. T. T
. T
ake carake car
ake carake car
ake car
e to ensure to ensur
e to ensure to ensur
e to ensur
e that the cap is secure that the cap is secur
e that the cap is secure that the cap is secur
e that the cap is secur
ely installed on the master cylinderely installed on the master cylinder
ely installed on the master cylinderely installed on the master cylinder
ely installed on the master cylinder
. If. If
. If. If
. If
it is loose or removed, it is likely that more fluid will drip during brake installation.it is loose or removed, it is likely that more fluid will drip during brake installation.
it is loose or removed, it is likely that more fluid will drip during brake installation.it is loose or removed, it is likely that more fluid will drip during brake installation.
it is loose or removed, it is likely that more fluid will drip during brake installation.
Place a drip tray or several rags directly below
the inboard brake line connection. If the area
around the brake line connection to the chassis
is dirty, clean it using brake cleaner or an ap-
propriate cleaning agent.
Loosen the hard line fitting, using an 11mm flare
wrench.
Remove the hard line fitting, and place one of
the rubber caps over the end of the hard line, to
control fluid loss during the installation.