User manual

9. Replacing the decorative door

panel, Fig. 7-9

Remove the two screws (1) from the upper hinge of

the door.

Pull the door together with the hinge away from the

housing and up off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame

and insert the new panel (7), so that the upper edge

of the panel runs exactly parallel to the upper edge of

the frame. A new panel can be inserted more easily

into the upper edge of the frame when the two corners

are cut off by approx. 5 x 5mm (8). Put the frame edge

(5) back in place and secure with screws.

Place the door on the lower hinge (9), slot the upper

hinge into the opening, press together with the door

against the housing and secure with the two screws

(11).

10. Customer service

Before you call a service engineer, carry out the

following simple tests:

Is there a power failure? Check the fuses.

Is the plug firmly connected to the socket and is the

socket switched on? Check the socket by plugging

in another appliance, e.g. a table lamp.

Is the thermostat at the correct setting? (normally 3

or 4).

Has the door not been closed properly causing the

inside temperature to rise too quickly?

Is the refrigerator level?

Has the defrosting button been inadvertently

pushed in?

If , so turn the thermostat dial to "0" and the

defrosting button will be released. Reset the dial to

its usual position and the refrigerator should start

cool again.

Has the ventilation become obstructed?

Figure 7.

Figure 8.

Figure 9