Installation Guide

Adapter Set- 2 Adapters, 3-
adhesive tubes, 3-Red Keys,
6 stainless screws, 1 alcohol
pad
Clean surface with alcohol
pad, let dry fully. Do not clean
with household cleaners!
Align adapter and pre-attach to bar with screws. This steps provides
for easy alignment and eliminates the need to measure from post
to post. Be sure to mark walls for desired height prior to pre-setting
to wall.
Carefully remove cover ring from each side. Foam ring will hold adapters
in place on wall and provide a border for the adhesive when inserted.
Press bar at desired location firmly for 5 seconds. Remove bar. Foam ring
will hold adapter in desired position
Pierce adhesive tube with red key and then slide tube end into slit in tube.
Insert tube end firmly into center hole in adapter and slowly insert
adhesive by turning red key. Continue until all three vent holes show a
white bead as pictured. Do not press on adapter after inserting glue.
Allow adhesive to cure for 24 hours
undisturbed. Important not to
disturb the adapter after inserting
glue.
After adhesive has cured for 24
hours, remove the three beads of
glue from the small vent holes
Attach bar to adapters using the screws included. Tighten firmly. Slide
cover ring over base and turn clockwise until properly aligned and turn
to lock in place. Job complete!
Grab Bar Installation Instructions (GB Series)