Use and Care Manual

Put Support Bar to hold Hammock(A) into Mid-Joint Supporting Bar(B).
Then attach using Bolt(H) with Hardware(E,F) using Bucket Wrench (L).
Tighten the bolts of this step securely.
Step 1
Step 2
Attach Mid-Joint Support Bar(B) to Ground Bar(C) using Bolt(D) & Washer(E), as shown
in the picture.
In this step, DO NOT tighten the bolts.
NOTE : Have a
couple of partners
/ assistants when
assembling this
step.
Note : The
COUNTERSINK
hole side of
Wooden Bar(B)
should be on
the outside.
Noble house Home Furnishings LLC 3 OF 7