Instructions / Assembly

ManualsBrandsNoble House ManualsDining Room SetsKwame 5-Piece Dark Grey Fabric and Natural Oak Dining Set

Label Picture Description QTY

A Front Leg (A) 1

B Front Leg (B) 1

C Back Leg (C) 1

Assembly Instructions

Caution : You must read this before you proceed

DINING CHAIR

Part List

WARNING: These chairs are intended only for normal use with all four chair

legs on the ground. These consumer chairs have relatively thin legs and are

not designed to be sat in with only two chair legs on the ground (as from

tipping back, forward, or to the side), and such can cause stress and failure

of one or more chair legs. Any misuse of the chairs voids any warranties,

express or implied.

Page 1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution : You must read this before you proceed DINING CHAIR WARNING: These chairs are intended only for normal use with all four chair legs on the ground. These consumer chairs have relatively thin legs and are not designed to be sat in with only two chair legs on the ground (as from tipping back, forward, or to the side), and such can cause stress and failure of one or more chair legs. Any misuse of the chairs voids any warranties, express or implied.
PAGE 2
D Back Leg (D) 1 E Cushion Chair Seat 1 Description QTY ① JCBC M6 x 60mm + S/W M6 + F/W 5/16" x 22mm 8 ② Allen Key M4 1 Hardware Label Picture Assembly Preparation Before Beginning Assembly: Assembly Steps Page 2 of 6
PAGE 3
Overview Cushion Seat (E) Back Leg (C) Back Leg (D) Front Leg (B) Front Leg (A) This Dining Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 2 Repeat Step 1, place the Front Leg (A) and Front Leg (B) on the corner block as shown. Then, fix the Front Leg (C) and (D) with JCBC Bolt ① using Allen Key ②. DO NOT FULLY TIGHTEN THE BOLT.
PAGE 5
Place the dining chair on a Level Surface to check if it wobbles. If it wobbles, lift the dining chair some 30cm to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the dining chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment. Test again for evenness on Level Surface. If no wobbles are found, proceed to tighten all the Bolts.
PAGE 6
Care & Maintenance Page 6 of 6