Caution : You must read this before you proceed Umbrella Base Reminder : Maximum diameter for open Umbrella - 80 inches Picture Label Picture Description QTY A Umbrella Base 1 B Support Pole 1 Page 1 OF 5
① Adjustable Screw 2 ② Bolt 1 ③ Washer 1 ④ 38mm & 48mm Adapter 1 ⑤ Gasket 1 ⑥ Socket Wrench 1 Before Beginning Assembly: WARNING: CHOKING HAZARD. Do not allow children to play with plastic wraps or any small parts in this package. Notice: As a safety precaution, when your Umbrella is not in use, please close the Umbrella. Remove Umbrella from this Base and store in safe location This Base is NOT suited and NOT recommended to be used as a free-standing Umbrella Base.
Overview 38mm & 48mm Adapter(④) Adjustable Screw(①) Support Pole(B) Umbrella Base(A) FRONT FACING This Umbrella Base has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Umbrella parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 This is a two person team assembly product.
Step 2 Screw in the Adjustable Screws(①) into the Support Pole(B) by hand. For Umbrella Pole with 48mm diameter: Insert the 38mm & 48mm Adapter(④) into the Support Pole(B). Pull out the 38mm Adapter; Then insert your 48mm Umbrella Pole. Tighten the Adjustable Screws(①) securely in a sequential manner to your Umbrella Pole. The Umbrella Base is ready for use. This Umbrella Base only be used on a flat, level surface.
Page 5 OF 5