Caution : You must read this before you proceed Barstool Label Picture Description QTY A Backrest 1 B Left Leg 1 C Right Leg 1 D Seat Panel 1 E Footrest 2
Label Picture Description QTY ① Allen Key 1 ② Bolt (M6*35) 10 ③ Bolt (M6*16) 9 ④ Bolt Cap 9 ⑤ Washer 19 Before Beginning Assembly: Overview Back Rest(A) Seat Panel(D) Left Leg(B) Footrest(E) Right Leg(C) Footrest(E) FRONT FACING This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective.
Step 1 Open the carton and place all the parts onto a clean, non-marring surface. Place Backrest(A) on the ground, as shown in picture above. Step 2 Attach Seat Panel(D) to Backrest(A) using Bolts(②) and Washers(⑤) with Allen Key(①). Do not fully tighten the Bolts. Step 3 Attach Left Leg(B) to Backrest(A) and Seat Panel(D) using Bolts(②) and Washers(⑤) with Allen Key(①). Do not fully tighten the Bolts. Step 4 Turn the partially assembled chair 180°.
Step 5 Attach Footrest (E) between the Legs using Bolts(③) and Washers(⑤) with Allen Key(①). Do not fully tighten the Bolts. Step 6 Attach Footrest (E) between the Legs using Bolts(③) and Washers(⑤) with Allen Key(①). Do not fully tighten the Bolts. Step 7 Place the Barstool on a LEVEL SURFACE to check for wobbles. If it wobbles, adjust the Legs Pre-installed Levellers until the Barstool is level with the ground. Adjust the levellers to the desired height to avoid wobbles.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.