Assembly Instructions Caution : You must read this before you proceed Table CAUTION : This table is NOT a TOY.Keep your child / children at bay during the assembly process.
Hard ware Label ① Picture Description Bolt(8*30mm) QTY 5 ② Washer(8mm) 5 ③ Spring Washer(8mm) 5 ④ Nut(8mm) 5 ⑤ Bolt (M6*30mm) 5 ⑥ Washer(6mm) 5 ⑦ Spring Washer(6mm) 5 ⑧ Nut(6mm) 5 ⑨ Spanner 1 ⑩ Screwdriver 1 ⑪ Rubber Cap（6mm） 5 ⑫ Rubber Cap（8mm） 5 Assembly Preparation Before Beginning Assembly: Noble house Home Furnishings LLC Page 2 OF 6
Assembly Step Overview Table Top(A) Table Leg with preattached levellers （B) Round Support(C) FRONT FACING This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, soft surface.
Step 3 ④ ③ ② B A Attach the table leg with pre-attached Levellers(B) to the table top(A) using washers(②),spring washers(③),and nuts(④) with spanner(⑩). DO NOT OVERTIGHTEN. Step 4 ④ ③ ② Repeat step 3, attaching the remaining 3 legs to the Table top(A). At this stage, only loosely tighten the Bolts. Step 5 Loosely attach the round support (C) to Table Leg with pre-attached Levellers(B) with nuts(⑧), washers(⑦), spring washers(⑥) and bolts(⑤), using the spanner(⑩).
Step 6 Stand the table right side up. Tighten the Levellers. Inspect it and make sure all parts are adequately connected. Now, fully and securely, tighten all nuts, at all joints. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. If there is still wobbles, loosen the bolts and execute this same process. If the Table is not stable it could lead to damage to the product.
Noble house Home Furnishings LLC Page 6 OF 6
