Instructions / Assembly

Label Picture Description QTY

①

L - Bracket 4

Hardware

Retrofit Instructions

Warning : You must read this before you proceed

FAUNA DINING CHAIR

WARNING: It is important that the instructions below are carefully

followed. Without this retofit, the legs of the chairs can break posing a fall

hazard to consumers. These chairs are intended only for normal use with

all four chair legs on the ground. These consumer chairs have relatively

thin legs and are not designed to be sat in with only two chair legs on the

ground (as from tipping back, forward, or to the side), and such can cause

stress and failure of one or more chair legs. Any misuse of the chairs

voids any warranties, express or implied.

PAGE 1
Retrofit Instructions Warning : You must read this before you proceed FAUNA DINING CHAIR WARNING: It is important that the instructions below are carefully followed. Without this retofit, the legs of the chairs can break posing a fall hazard to consumers. These chairs are intended only for normal use with all four chair legs on the ground.
PAGE 2
② CSK Screw M3.5 x 16mm 8 Description QTY Allen Screwdriver (not provided) 1 Required Tools Label Picture ① Assembly Steps Step 1:Turn the chair upside down with the seat positioned on the table, as shown in the instructions. Place the L-Bracket ① in the joint where the chair leg meets the base of the chair, as illustrated. Step 2:Screw the L-Brackets ① into place, in each joint, one at a time using the provided screws ②.