Caution : You must read this before you proceed Table Label Picture Description QTY A Table Top 1 B Table Base 1 C Support Ring 1 Noble House Home Furnishings LLC.
Label Picture Description QTY ① Nut 9 ② Spanner 1 Before Beginning Assembly: Overview Table Top (A) Support Ring (C) Table Base (B) This Table has multiple parts and may require up to 20 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise the parts and steps before assembly. Noble House Home Furnishings LLC.
Step 1 B A C Unpack and place all parts on a clean, non-marring surface. Step 2 A Lay the Table Top(A) facedown onto a clean, non-marring surface. Step 3 ① C C A A Attach the Support Ring(C) to Table Top(A) using Nuts(①) with Spanner(②). Do not fully tighten the Bolts. Noble House Home Furnishings LLC.
Step 4 B C B C A Attach the Support Ring(C) to Table Base(B) using Nuts(①) with Spanner(②). Tighten all Nuts at all joints in a sequential manner. Step 5 Stand the Table up. Adjust the Pre-installed Levellers at the bottom of the Table Base until the Table is level to the ground. Step 6 Your Table is ready for use. This Table can only be used on a flat, level surface. Noble House Home Furnishings LLC.
Noble House Home Furnishings LLC.
Caution : You must read this before you proceed Chair Label Picture Description QTY A Chair Seat 1 B Chair Leg (Left) 1 C Chair Leg (Right) 1 Noble House Home Furnishings LLC Page 1 OF 7
Label Picture Description QTY ① Bolt (M8*35MM) 7 ② Washer 7 ③ Allen Key 1 Before Beginning Assembly: Noble House Home Furnishings LLC Page 2 OF 7
Overview Chair Seat (A) Chair Leg (C) Chair Leg (B) Front Facing This Chair has multiple parts and may require up to 30 minutes or more to assemble. To give you an overview of the Chair, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 A B C Unpack and place all parts on a clean, non-marring surface.
Step 2 A (3.1) Place the Chair Seat(A) facedown as shown above. Step 3 C ③ C ② ① A A Align the mounting positions on Chair Leg(C) and Chair Seat(A), then attach using Bolts(①) and Washers(②) with Allen Key(③). Do not fully tighten the Bolts.
Step 4 B B B ② ① ③ AA B C A Align the mounting positions on Chair Leg(B) and Chair Seat(A), then attach using Bolts(①) and Washers(②) with Allen Key(③). Do not fully tighten the Bolts. Step 5 Stand the Chair up. Carefully and gently sit into the Chair, this action will ensure there are no gaps between the parts. Then proceed to tighen all Bolts at all joints in a sequential manner.
Step 6 Adjust the Pre-installed Levellers at the base of the Legs until the Chair is level to the ground. Step 7 Your Chair is ready for use. This Chair can only be used on a flat, level surface.
Noble House Home Furnishings LLC Page 7 OF 7