Instructions / Assembly

Assembly Step
Turn the Table rightside.
Adjust the Legs pre-installed Levellers until the table is level with the ground.
Upon completion of full assembly, bolt up and tighten up all screws.
Your table is now ready for use.
Lay the Table Top(D),Top being floor facing, onto a flat soft clean surface .
Fix the Studs(F) to the table Top(D) with the Screwdriver(I).
Then attach the Table Legs(E) to the the Table Top(D) using washers,Spring
washers,and Nuts(H) with the Spanner(J).
DO NOT OVER TIGHTEN,yet.
Attach the leg support(K)to Table Legs(E) using Bolts(G), Washers,Spring
washers, and Nuts（H）.
Use one Screwdriver (I) to hold the bolt, and with the other Spanner (J), turn in
the Nut(H).
DO NOT OVER TIGHTEN, yet.
Unpack and place all parts on a clean soft surface.
3 OF 4