Caution: You must read this before you proceed.
Before Beginning Assembly: Unpack all the parts for a clear overview. Overview Table Top(A) Leg Panel(B) Leg Support Panel(C) This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts on a clean, non-marring surface. Turn table top upside down,then attach Leg Panels (B) to the Table Top(A) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above. Repeat this process with the other Leg Panel (B) Do not fully tighten the Bolts. Step 2 Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above.
Step 3 If wobble Test again 30CM~50CM Place the table on a LEVEL SURFACE to check for wobbles. If it wobbles,with 2 to 3 adult partners, lift the table to some 20cm to 30cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the table freely and vertically with the four legs, hitting the ground, all at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
Page 5 OF 5
Caution : You must read this before you proceed DINING CHAIR Label Picture Description QTY A Left Armrest 1 B Right Armrest 1 C Seat 1 Noble House Home Furnishings LLC Page 1 OF 6
D Backrest 1 E Seat Cushion 1 Description QTY ① Bolt (M6*30MM) 9 ② Washer 9 ③ Allen Key 1 Label Picture Before Beginning Assembly: Noble House Home Furnishings LLC Page 2 OF 6
Overview This Dining Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all the parts onto a clean, non-marring surface.
Step 2 Attach the Backrest(D) to the Left Armrest(A) and Right Armrest(B) using Bolts(①) and Washers(②) with Allen Key(③) as shown in the picture. Do not fully tighten the Bolts. Step 3 Align the Seat(C) with Left Armrest(A), Right Armrest(B), and Backrest(D). Attach Seat(C) to Left Armrest(A), Right Armrest (B) and Backrest(D) using Bolts(①) and Washers(②) with Allen Key(③) as pictured. Tighten all Bolts at all joints sequentially. DO NOT tighten any Bolt fully and then move on to the next one.
Step 4 Put the Seat Cushion(E) on the Chair. Your Dining Chair is ready for use. This Dining Chair can only be used on the flat, level surface.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing minimizing exposure exposure to to direct direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface.