Instructions / Assembly

Step 1

Step 2

Put the chair back( A) onto a flat table or panel.

Align the positioning dowels on the chair seat panel with the holes

located on the chair back panel.

Use your left hand to push the seat frame floorwards, depicted by

Arrow 1.

This action helps to ensure the chair seat(B) is pressed towards to

the chair back(A) with no gap between these.

Then, lock the middle hole and the corner holes.

The hardware for these are : Four Dia.M8 Bolt:90mm(b)+one Dia.M8

Bolt:60mm(a)+five spring washer(c)+five flat washer(d)with the Allen

key(e).

At this point of assembly, DO NOT overfasten the connections.

Place the Chair Back(A) on a soft surface to avoid any scratches or

damages to the product.

REMOVE the Seat Base Cover from the Chair Seat(B), take out the

front legs and hardware accessories.

4 OF 7