Caution: You must read this before you proceed.
Label Picture Description Bolt (M8*50MM) Bolt (M8*60MM) QTY ③ Washer 11 ④ Spring Washer 11 ⑤ Allen Key 1 ① ② 6 5 Before Beginnin g Assembl y: Overview Chair Back(A) Chair Seat(B) FRONT FACING Front legs(C) Noble house Home Furnishings LLC 2 OF 6
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 B ⑤ A ② ④ ③ C Place the Back with Legs(B) on a clean, non-marring surface.
Step 3 C ③ ④ ① B ⑤ A Place the Pack of Seat(A) and Back with legs(B) on the side of a table with the Seat(A) facing down, as seen in the picture. Insert Front Leg(C) into the mounting position of Seat(A) and attach using Bolts(①), Spring Washers(④) and Washers(③) with Allen Key(⑤). Do not fully tighten the Bolts. Repeat the same process to attach the remaining one Leg. Attach each leg using 2 Bolts.
Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the bolts.
Noble house Home Furnishings LLC 6 OF 6