Use and Care Manual

Step 2
2.1) Turn the Table top (A) up side down as shown in picture above.
2.2) Attach the Leg (B) to Seat panel (A) by using Bolts (①), Flat washer (②) and Allen Key (③
) as
shown in picture above.
Repeat the same process to attach the 3 remaining Legs (B) into the Table Top (A).
Do not fully tighten the Bolts.
2.1
2.2
Noble House Home Furnishings LLC Page 4 of 5
Step 3
Turn the Table back to normal flat ground
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Bolts/Screws until evenly secured.
Inspect the Table and make sure all parts are adequately connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Noble House Home Furnishings LLC Page 4 of 5