Caution: You must read this before you proceed.
Part NO.
Before Beginning Assembly: Unpack ang place all parts for clear visibility Pack A for assembling the Leg Frame(B) to the Chair Seat(A) 9pc of 50mm Long Bolts + 9pc of Flat Washer Ring + 9pc of Spring Washer +one Allen Key Pack B for assembling the Side Rails(C) to the Leg Frame(B) 1pc of Screwdriver + 5pcs ¢4*50mm Screws Page 3 OF 7
Step 1 A.Bar Stool Seat C.Side Rails B.'H'Leg Frames-when assembling, the BOLT points must be INWARD facing. Place the Bar Stool Seat(A)onto a soft surface to avoid any scratches ordamages to the product. REMOVE the Seat Base Cover from the underside of the Bar Stool Seat (A), take out the Side Rails(C)and hardware.
Insert the 'H'Frame Legs(B)into the Seat Frame (A)use "PACK A"to connect these. Insert the Side Rail(C)with the bottom side up into the Leg Frame(B). WARNING !! DO NOT OVER TIGHTEN. OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT. TIGHTEN ONLY UNTIL SECURE. Step 3 Next, place the chair onto the side of a table as seen in Picture 1. You will now have the chair bottom and legs facing skywards. Insert the other'H'Leg Frame (B)into the Seat Frame(A). Then insert the Side Rail(C)into the Leg Frame(B).
Step 4 Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the bolts.
Page 7 OF 7