Instructions / Assembly

Step 1
Step 2
Step 3
For the Umbrela Pole with diameter as 35mm, use Dia.
35mm Adapter (H) & Dia. 38mm Adapter (I) added
together, insert the Dia. 38mm Adapter (I) into the
Support Pole (E) first, and then put the Dia. 35mm
Adapter (H) onto the Dia. 38mm Adapter(I).
Turn the Cap(G) onto the Support Pole(E) to hold the
Adapters in place.
The Umbrella Base is fully assembled and ready for use.
For the Umbrela Pole with diameter as 38mm, use the
Dia. 38mm Adapter (I) only, insert the Dia. 38mm
Adapter (I) into the Support Pole (E).
Turn the Cap(G) onto the Support Pole(E) to hold the
Adapters in place.
The Umbrella Base is fully assembled and ready for
use.
This is a 2-person team assembly product.
Tilt the Umbrellas Base to its side as pictured.
Put the Locking Bolt (C) through the base from the hole on the bottom.
Screw the Washer(B)to fastening the Locking Bolt(C).
Adding the Decorative Ring (D) onto the Washers (B).
Screw the Support Pole (E) onto the base.
Screw the Adjustable Screw (F) into the Support Pole（E）.
3 / 4