Stool Chair Caution : You must read this before you proceed.
Label Picture Description Qty A Seat 1 B Leg 4 Description Bolt Dia.
Step 1 Position the Chair on its reverse side, as shown in above picture, preferrably on a surface that will not scratch the upholstery. Remove the non-woven bottom cover. Take out 04 pcs of Wooden Legs and a bag of hardware (9 bolts and 1 Allen key). Step 2 Install the legs on the leg position located on the underside of the Bench. Make sure the 'overhang' on the Leg Frame is facing outwards. Slide-insert the grooves of the Wooden Legs into the tenons on the Bench.
Step3 Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the bolts.