Use and Care Manual

Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(③) and Washer(②) with Allen Key(①)
as shown in the picture above.
Repeat the same process to affix the another Leg Support Panel(C)
Do not fully tighten the Bolts.
Open the carton and place all the parts on a clean, non-marring surface.
Turn table top upside down, then attach Leg Panel (B) to the Table Top(A) using Bolt(③) and
Washer(②) with Allen Key(①) as shown in the picture above.
Repeat this process with the other Leg Panel(B)
Do not fully tighten the Bolts.
Step 2
Step 1
Page 3 OF 5