Assembly Instructions Caution : You must read this before you proceed. Bar Table CAUTION : This table is NOT a TOY. Keep your child / children at bay in the process of assembly.
No. Picture Description Qty Pedestal - Lower 1 Pedestal - Upper 1 Table Base 1 'X' Plate 1 Table Top 1 Description Qty Studs(M8*38mm） 5 Washers ( 8mm ) 5 Springs Washers ( 8mm) 5 Nuts ( 8mm ) 5 Bolts (M8*30mm ) 5 Washers ( 8mm ) 5 Spring Washers (8mm ) 5 Nuts ( 8mm ) 5 Washers ( 12mm ) 2 Spring Washers ( 12mm ) 2 Nuts ( 12mm ) 2 I Spanner（8mm） 2 J Screwdriver 1 K Spanner（12mm） 1 A B C D E No.
Before Beginning Assembly: Step 1 Unpack all parts. To avoid any scratch or damage to the products, place onto a clean and flat, soft surface. To the underside of the table top, there are 4 (four) assembly points. Insert Studs(F) into these 4 (four) positions with Screwdriver(J). Fully tighten the studs.
Step 2 Affix 'X' Plate (D) to the top of Upper Pedestal (B). Align the holes on the 'X' Plate(D) with the holes on the top of Pedestal (B). Then, insert the Bolt(G) from the 'X' Plate to the Pedestal. Then, fix the bolt with Spring Washer & Washer & Nut (G) using Spanner(I). Fully tighten all the nuts. Step 3 Attach the 'X' Plate, from Step 2, to the Table Top(E). Insert the holes on the 'X' plate to the pre-attached Bolts on the Table Top(E).
Step 5 WARNING : DO NOT LIFT UP the Table base to assemble as shown in picture 1 Have your partner hold the Table Top on its side as shown in picture 2. Insert the screw on the Pedestal - Lower (A) to the hole on the table base(C). Using the Spanner(I), turn in and tighten : Flat Washers, Spring Washers and Nuts(H). Fully tighten the Nut. Step 6 Ensure all Bolts and Screws are FULLY TIGHTEN UP. Turn the table right side up.
OF 6
