Caution : You must read this before you proceed Barstool Label Picture Description QTY A Left Armrest with Leg 1 B Right Armrest with Leg 1 Page 1 OF 7
C Backrest 1 D Seat 1 E Seat Cushion 1 F Footrest 2 Description QTY ① Bolt (M6*30mm) 7 ② Bolt (M6*15mm) 9 ③ Washer 16 ④ Allen Key 1 Label Picture Before Beginning Assembly: Page 2 OF 7
Overview Backrest(C) Left Armrest with Leg(A) Seat(D) Seat Cushion(E) Right Armrest with Leg(B) Footrest(F) Front Facing This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all parts on a clean, non-marring surface.
Step 2 Place the Backrest(C) face up. Attach the Seat(D) to the Backrest(C) using Bolts(①) and Washers(③) with Alley Key(④). Do not fully tighten the Bolts. Step 3 Dowel Place the Left Armrest with Leg(A) face down on the soft and clean surface. Insert the Dowel on the Backrest(C) into the mounting position of the Left Armrest with Leg(A). Attach the Backrest(C) and Seat(D) to the Left Armrest with Leg(A) using Bolts(①) and Washers(③) with Alley Key(④). Do not fully tighten the Bolts.
Step 4 Dowel Place the Right Armrest with Leg(B) face down on the soft and clean surface. Insert the Dowel on the Backrest(C) into the mounting position of the Right Armrest with Leg(B). Attach the Backrest(C) and Seat(D) to the Right Armrest with Leg(B) using Bolts(①) and Washers(③) with Alley Key(④). Do not fully tighten the Bolts. Step 5 Place the Footrests(F) beween the Legs as shown. Attach the bottom side of Footrest(F) to the Legs using Bolts(②) and Washers(③) with Alley Key(④).
Step 4 Place the Barstool on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Barstool some 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the Barstool freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the Bolts and gaps all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles are found, proceed to tighten all the Bolts.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.
