Instructions / Assembly

Affix loosely the Legs (B) into the mounting position at the corners of the Table Top (A), using
the Long Bolts (①) with Spring Washers (②), Flat Washers (③), as shown in the picture.
Repeat the same process with the other Legs (B).
Only loosely tighten the Screws.
Step 6
With assistance from your adult partners,Turn the Table right side up.
Inspect it and make sure all parts are adequately connected.
Check to ensure there is NO WOBBLENESS.
In a sequential manner, ensure all bolts and screws are fully locked into position and secured.
CAUTION : When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one. This would cause the
frame to warp.
If there is still wobbles, loosen the screws and execute this same drop tests.
WARNING!! IF TABLE IS NOT STABLE , IT COULD LEAD TO DAMAGING THE PRODUCT.
Ensure all screws are fully locked into position.
The Table is ready to be used.
Caution: This Table can only be used on a flat, level surface.
Step 7