Caution : You must read this before you proceed Club Chair Label Description QTY A Chair 1 B Right Front Leg(Labelled B) 1 C Left Front Leg(Labelled C) 1 D Picture Back Leg(Labelled 2 D) Page 1 OF 6
Label Picture Description QTY ① Bolt (M8*60MM) 9 ② Spring Washer 9 ③ Washer 9 ④ Allen Key 1 Before Beginning Assembly: Page 2 OF 6
Chair(A) Back legs(D) Right Front Leg(B) Left Front Leg(C ) FRONT FACING This Club Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Position Chair(A) on its back as shown. (DO NOT place on surface that can scratch or damage upholstery.
Step 2 ④ A ① ② ③ B C D D Insert the Back Leg(D) into the mounting position of Chair(A) . Attach the Back Leg(D) using Bolts(1) , Spring Washers(2) and Washers(3)with Allen Key(4). Repeat the same process to install the remaining three Legs. At this stage, Loosely tighten these bolts. Step 3 Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, press firmly down on both armrests at the same time. This will help to ensure all Bolts and gaps reach full alignment status.
Step 4 Turn over the product upsidedown onto a flat ,no-marring surface(as shown in picture) ,Smooth down with your hand on the Magic Tape on all 4 sides at the edge of the seat box. Step 5 Place the Club Chair right side up,Make sure all parts are connected and securely locked into position. Your Club Chair is ready for use. This Club Chair can only be used on a flat, level surface.
Page 6 OF 6