Caution : You must read this before you proceed End Table Picture Label Picture Description QTY A Top Panel 1 B Left Side Support Bar 1 C Right Side Support Bar 1 D Base Support Bar 1 1 OF 8
Label Picture Description QTY ① Bolt (M6*35MM) 5 ② Bolt (M6*20MM) 3 ③ Allen Key 1 Before Beginning Assembly: 2 OF 8
Overview Top Panel (A) Right Side Support Bar (C) Left Side Support Bar (B) Base Support Bar (D) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all the parts onto a clean, non-marring surface.
Step 2 Attach the Side Panel(B) to Top Panel(A) using Bolts(①) with Allen Key(③) as shown above. Do not fully tighten the Bolts. Step 3 Attach the Side Panel(C) to Top Panel(A) using Bolts(①) with Allen Key(③) as shown above. Do not fully tighten the Bolts.
Step 4 Attach the Base Support Bar(C) to Side Panel(B) and Side Panel(C) using Bolts(②) with Allen Key(③). Do not fully tighten the Bolts.
Stand the Table up. Place the Table on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and carefully, push down onto the Table. This will help to align all parts at all the joints. Then, in a sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. This may cause the frame to warp. If there are still wobbles, loosen the Bolts and execute the same process.
OF 8
OF 8