Instructions / Assembly

Step 2
Place the chair onto the side of a table as seen in picture 1.
Position Left Front Leg(D) into Chair Seat(B) and attach using Bolts(②), Spring
Washers(④) and Washers(③) with Allen Key(⑤).
Repeat same step to attach Right Front Leg (C) to Chair Seat(B).
Do not fully tighten Bolts.
WARNING!! DO NOT POSITION THE FRONT LEG AS SHOWN IN PICTURE 2.
Place the Chair Seat(B) Face down on a soft surface to avoid
any scratches or damages to the product.
Carefully peel away the Seat Base Cover from the edge,take
out the legs and hardwares from the Bottom of the Chair Seat
（B).
Put the Chair Back(A) onto a flat, clean, non-marring table.
Align the mounting positions of the Chair Back(A) and Chair Seat
(B).
Use your left hand to push the seat floorwards, depicted by Arrow
1.
This action helps to ensure the Chair Seat(B) is pressed towards
to the Chair Back(A) with no gap between them.
Using Bolts(①), Spring Washers(④) and Washers(③) with Allen
Key(⑤) as shown above.
Do not fully tighten Bolts.
Step 1
Step 1.2
（1）
（2）