Caution: You must read this before you proceed Single Chair Label Description QTY A Side Panel 2 B Back Support Bar 1 C Seat (Labeled with face and bottom) 1 Description QTY Bolt:M6*20MM 10 Label D Picture Picture
E Allen Key 1 F Seat Cushion 1 G Back Cushion 1 Before Beginning Assembly: Step 1 Take out the silders in the four ends of the Seatboard(C ) using Allen Key(E ).
Step 2 Insert the Seat(C) onto the Side Panel(A), as shown in the picture. Step 3 Attach Seat(C) and Side Panel(A) using Bolt(D) with Allen Key(E) as shown in the picture. Loosely tighten the Bolts. Step 4 Attach Back Support Bar(B) to Side Panel(A) using Bolt(D ) with Allen Key(E). Loosely tighten the Bolts.
Step 5 Repeat Step1 to Step 3 to attach the second Side Panel(A). Place chair upright and test for stability. Then in a sequential manner, proceed to fully tighten all Bolts at all joints. Step 6 Stand the Chair up. Put Back Cushion(G) and Seat Cushion(F) on the Chair, and stick the vercro. Your Single Chair is ready for use.