Caution : You must read this before you proceed Table Label Description QTY A Table Top (Without Glass) 1 B Table Leg 4 C Glass 1 Description QTY ① Iron Bar (Nut at one end) 5 ② Wrench 1 ③ Socket Wrench 1 ④ Nut 5 ⑤ Washer 5 ⑥ Leg Cap 5 ⑦ Adjustable Glider Foot Label Picture Picture 5 1 OF 6
Before Beginning Assembly: Overview Table Top ( A ) Glass ( C ) Table Leg ( B ) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Position the Table Top(A) facedown on a clean, non-marring surface. Insert Iron Bar(①) with Nut downward into mounting position at the corner of the Table and tighten with Wrench(②) until locked into position. Repeat the same process with the remaining three Iron Bars(①). Fully tighten all Iron Bars. Step 2 Insert the Leg(B) onto the Iron Bar(①) as pictured above. Thread the Iron Bar(①) through the mounting position at the base of the Leg(b) until threading on the Iron Bar(①) is clearly visible.
Step 3 Attach Leg(B) to Table Top(A) by placing a Washer(⑤) and Nut(④) onto the Iron Bar(①) and tightening with Socket Wrench(③). Repeat the same process with the other three Legs. Tighten the Nuts fully in a sequential manner. Step 4 Insert Leg Caps(⑥) into the base of the Legs(B) as pictured above. Step 5 Screw Adjustable Glider Feet(⑦) into mounting positions on Leg Caps(⑥) by hand.
Step 6 Adjust height for balance Adjust height for balance Then, with the assistance from an adult partner, stand the Table upright. Turn the Legs Adjustable Glider Feet(⑦) until the Table is level with the ground. To adjust the Glider Feet, with the help from an adult partner, tilt the table to rest on two feet. Adjust the Glider Feet to the desired height to avoid wobbles. Step 7 Carefully place the Glass(C) onto the Table Top. Step 8 Your Table is ready for use.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.