Caution : You must read this before you proceed Loveseat Label Picture Description QTY A Left Side Panel 1 B Right Side Panel 1 C Seat Panel (with plastic plugs protector in 4 ends) 1 D Back Support Bar 1 E U Shape Board 1 F Middle Cushion 1 G Seat Cushion 2 H Back Cushion 2
Label Picture Description QTY ① Bolt (M6*20MM) 10 ② Allen Key 1 Before Beginnin g Assembly : Overview Back Support Bar(D) Right Side Panel(B) Back Cushion(H) Left Side Panel(A) Seat Panel(C) U Shape Board(E) Seat Cushion(G) Middle Cushion(F) FRONT FACING This Loveseat has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Loveseat parts, the above picture is to help you put the various parts into perspective.
Step 1 Open the carton and place all the parts onto a clean, non-marring surface. Remove the plastic plugs (protect the aluminum from deforming) from the four ends of the Seat Board(C) using Allen Key(②) as shown above. please keep plastic plugs for re-package if need. Place the Left Side Panel(A) with its inside facing up. Insert Seat Panel(C) into the Left Side Panel(A). Step 2 Step 2.1 Step 2.2 2.1) Attach Seat Panel(C) to Left Side Panel(A).using Bolts(①) with Allen Key(②) as shown above. 2.
Step 3 Insert the Back Support Bar(D) into the Left Side Panel(A). Step 4 Attach Back Support Bar(D) to the Side Panel(A) using Bolt(①) with Allen Key(②). Do not fully tighten the Bolt. Step 5 Insert the Right Side Panel(B) into the Back Support Bar(D) and Seat Panel(C) as shown above.
Step 6 Step 6.1 Step 6.2 Step 6.3 6.1) Attach Right Side Panel(B) to Seat Panel(C) using Bolts(①) with Allen Key(②) as shown above. 6.2) Attach Right Side Panel(B) to Seat Panel(C) using Bolts(①) with Allen Key(②) as shown above. 6.3) Attach Back Support Bar(D) to Right Side Panel(B) using Bolt(①) with Allen Key(②)as shown above. Do not fully tighten the Bolts. Step 7 Stand the Loveseat up. Place the Loveseat on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected.
Step 8 H H G F G Put Seat Cushions(G), Back Cushions(H), and Middle Cushion(F) on the Loveseat. Then stick the velcro from the Back Cushions to the Seat Cushions as shown above. Step 9 Put the U Shape Board(E) on the Middle Cushion(F) as shown above. Your Loveseat is ready for use. This Loveseat can only be used on a flat, level surface.