Installation Guide

ManualsBrandsNoble House ManualsGazebos9.75 ft. 9.75 ft. Dark Gray Steel Canopy Gazebo with Water-Resistant Fabric Curtains

Caution : You must read this before you proceed

Read all instructions before assembling and using this product.

1. Select ideal location. Set out all parts on a clear and level surface prior to assembly.

Ideally, the Gazebo should be set up in the desired location to avoid moving it after

assembly.

2. Team Work. We recommend 4-5 adults and it may require 3 to 4 hours to fully

assemble the Gazebo. If possible, please use safety ladders.

3. Use caution. During the entire assembly process, especially when lifting heavy or

large parts or using ladders, pay attention to safety. No one other than the adult

assistants should be allowed in the work area.

4. Check all available parts. Before assembling your Gazebo Frame, make sure that you

have all the parts described in the Parts List.

5. Ensure that ALL BOLTS and NUTS are fully and securely tightened before you

proceed to attach the Canopies.

6. Keep children away. Children shouldn’t be allowed in the work area. Do not let them

handle parts and tools. Do not allow children to climb the Gazebo.

Gazebo

Noble House Home Furnishings LLC

Page 1 OF 11

Summary of content (11 pages)

PAGE 1
Caution : You must read this before you proceed Read all instructions before assembling and using this product. 1. Select ideal location. Set out all parts on a clear and level surface prior to assembly. Ideally, the Gazebo should be set up in the desired location to avoid moving it after assembly. 2. Team Work. We recommend 4-5 adults and it may require 3 to 4 hours to fully assemble the Gazebo. If possible, please use safety ladders. 3. Use caution.
PAGE 2
Label Picture Description QTY A Side Panel 8 B Long Corner Roof Bar 4 C Column 4 D Short Roof Bar 4 E Top Connector 1 F Base 4 G Side Panel Top Connector 4 H Side Panel Bottom Connector 4 I Decorative Ball 5 J Canopy 1 K Curtain 4 L Mosquito Netting 4 M Corner Brace 8 N Hang Tube Clip 32 O Sidewall Hang Tube 16 Noble House Home Furnishings LLC Page 2 OF 11
PAGE 3
Label Picture Description QTY ① Bolt (M6*15mm) 25 ② Bolt (M6*25mm) 17 ③ Bolt (M6*70mm) 5 ④ Bolt (M6*75mm) 17 ⑤ Bolt (M6*65mm) 9 ⑥ Bolt Cap 53 ⑦ Nut 53 ⑧ Nut Cap 69 ⑨ Washer 69 ⑩ Spanner 2 ⑪ Curtain Ring 64 ⑫ Stake 9 Noble House Home Furnishings LLC Page 3 OF 11
PAGE 4
Before Beginning Assembly: Noble House Home Furnishings LLC Page 4 OF 11
PAGE 5
Overview Top Connector (E) Long Corner Roof Bar (B) Short Roof Bar (I) Canopy (J) Side Panel (A) Decorative Ball (I) Corner Brace (M) Column (C) Curtain (K) Base (F) Mosquito Netting (L) This Gazebo has multiple parts and may require up to 4 hours to assemble.To give you an overview of the Gazebo parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 1.
PAGE 6
Step 2 Attach Column(C) between Side Panels(A) using Bolts( ⑤), Washers(⑨), and Nuts(⑦) with Spanners(⑩). Repeat this process with the remaining Side Panels(A) and Columns(C). Tighten the Bolts and Nuts fully in a sequential manner. Then cover the Bolts and Nuts with Bolt Caps(⑥) and Nut Caps(⑧). Step 3 Attach Side Panels(A) using Bolts(①), Washers(⑨), and Nuts(⑦) with Spanners(⑩). Repeat this process with the remaining Side Panels(A) until all Side Panels are connected.
PAGE 7
Step 4 Attach Side Panel Top Connector(G) and Side Panel Bottom Connector(H) to Side Panels(A) using Bolts(②), Washers(⑨), and Nuts(⑦) with Spanners(⑩). Repeat this process with all Side Panel Top Connectors(G) and Side Panel Bottom Connectors(H) and Side Panels(A). Note: Please use a ladder, if you can't reach it. Tighten the Bolts and Nuts fully in a sequential manner. Then cover the Bolts and Nuts with Bolt Caps(⑥) and Nut Caps(⑧).
PAGE 8
Step 6 Insert the Long Corner Roof Bars(B) and Short Roof Bars(D) into the Top Connector(E). Step 7 Insert the Long Corner Roof Bars(B) into the Columns(C) and the Short Roof Bars(D) into the Side Panel Top Connectors(G) one-by-one. Note: Please use a ladder, if you can't reach it.
PAGE 9
Step 8 8.1 8.2 8.1) Put the Canopy(J) onto the Gazebo Roof Fram e. Insert the bolts on the Decorative Balls(I) into the ring of Canopy(J), then screw the Decorative Balls into the Columns(C) and Top connector(E). 8.2) Then securely fasten the Canopy(J) into position using the velcro strips. Note: Please use a ladder, if you can't reach it. Step 9 Attach the Bases(F) to Columns(C) using Bolts( ③), Washers(⑨), and Nuts(⑦) with Spanners(⑩). Tighten the Bolts and Nuts fully in a sequential manner.
PAGE 10
Step 10 Install the Mosquito Netting(L) along the inside Sidewall Hang Tubes(O) using the Curtain Rings(⑪) as pictured above. Step 11 Install the Curtains(K) along the outside Sidewall Hang Tubes(O) using the Curtain Rings(⑪) as pictured above. Affix the Gazebo to the ground by inserting the Stakes( ⑫) through the Bases(F). Your Gazebo is ready for use. This Gazebo can only be used on a flat, level surface. CAUTIONS: 1. Check stability and then tighten the Bolts and Nuts. 2.
PAGE 11
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.