Instructions / Assembly

Step 3

Step 4

Step 5

Stand the Table up and check for stability.

Then proceed to tighten all Bolts at all joints.

Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, in a

sequential manner, gradually tighten each Bolt until all bolts are evenly secured. This

methodology will ensure maximum evenness once all Bolts are fully tightened.

Carefully place the Glass Top(A) on the assembled Table Frame as show above.

Your Table is ready for use.

This Table can only be used on a flat and level surface.

Attach Leg(B) to Top Side Bars(C) and Footrests(D) using Bolts(②) with Allen Key(③) as

shown above.

Attach Leg(B) to Top Side Bars(C) and Footrests(D) using Bolts(①) with Allen Key(④) as

shown above

Do not fully tighten the Bolts.

Page 4 OF 5