Instructions / Assembly

Step 3
Place the Right Armrest / Leg (C) as pictured above and affix to Right Armrest / Leg(C) and
Hardware( ) with Allen Key( ) as shown in Picture 4.
Do not fully tighten the bolts.
Step 4
Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather, In a
sequential manner, gradually tighten each Bolt until all bolts are evenly secured. This
methodology will ensure maximum evenness once all Bolts are fully tightened.
Step 5
4
Page 4 OF 6
A
C
3
6
3 4
4
5
6
Connect the Armrest/Leg (C&D) to Backrest (A)
using Hardware( )with Allen Key ( ) as shown in Picture 5 and Picture 6
Place the Single Chair on a LEVEL SURFACE to check for wobbles.
Check for stability and then tighten all Bolts at all joints.
If it wobbles, lift the Single Chair some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
1
4
6
C
D
4
6
6
1
4
6
1
4
Seat(B) using