Caution : You must read this before you proceed Table Label Picture A B C Noble House Home Furnishings LLC Description Table Top Table Leg Leg Support QTY 1 2 1 Page 1 OF 6
Description QTY ① Bolt (M8*20MM) 5 ② Washer (M8) 5 ③ Spring Washers (M8) 5 ④ Bolt (M6*20MM) 5 ⑤ Washer (M6) 5 ⑥ Spring Washers (M6) 5 ⑦ Spanner 1 Label Picture Before Beginning Assembly: Noble House Home Furnishings LLC Page 2 OF 6
Overview Table Top (A) Table Leg (B) Leg Support (C) This Table has multiple parts and may require up to 30 minutes or more to assemble. To give you an overview of the Table, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 A Place the Table top (A) facedown as shown above.
Step 3 B ⑦ ① ③ ② A Align the mounting positions on Table leg (B) and Table top (A), then attach using Bolt(①), Washer(②) and Spring Washers(③) with Spanner(⑦). Do not fully tighten the Bolts. Step 4 B ⑦ ① ③ ② A Repeat step 3, attaching the other Table leg(B) to the Table Top(A). Do not fully tighten the Bolts.
Step 5 C ⑤ ⑥ ④ ⑦ A Attach the Leg support (C) to Table Legs(B) using Bolts(④), Washer(⑤),Spring washers(⑥) with Spanner(⑦). Then proceed to tighen all Bolts at all joints in a sequential manner. Step 6 Adjust height for balance Adjust low for balance Adjust the Pre-installed Levellers at the base of the Legs until the Table is level to the ground. Step 7 Your Table is ready for use. This Table can only be used on a flat, level surface.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.