Instructions / Assembly

ManualsBrandsNoble House ManualsOutdoor Bar FurnitureRiviera Wood Patio Serving Bar

Page 1 of 8Page 1 of 8

Assembly Instructions

Caution : You must read this before you proceed.

BAR CABINET

CAUTION : This PRODUCT is NOT a TOY.

Keep your child / children at bay during the assembly process.

For turning/lifting the Bar Table and to prevent damage to the Bar

Table, three adults are required.

Noble House Home Furnishings LLC

Summary of content (8 pages)

PAGE 1
Assembly Instructions Caution : You must read this before you proceed. BAR CABINET CAUTION : This PRODUCT is NOT a TOY. Keep your child / children at bay during the assembly process. For turning/lifting the Bar Table and to prevent damage to the Bar Table, three adults are required.
PAGE 2
Assembly Preparation Before Beginning Assembly: Parts List NO.
PAGE 3
Hard ware I Long Screws (M7x90mm) 5 K Medium Screws (M6x50mm) 11 L Short Screws (M6x25mm) 7 M Allen Key 1 Assembly Step Unpack and place all parts on a clean, non-marring surface. Place the Base Stand(G),right side up. Align and insert Front Panel(B) into Base Stand(G) by inclining the corner, as pictured above. Then, gently slide the entire Front Panel(B) into this slot housing. CAUTION : This panel must be held in position whilst the SIDE PANELs are being attached.
PAGE 4
Pic. 2 Pic. 1 Align and insert Left Side Panel(C), Right Side Panel(D) into Base Stand(G) with Tenons on the Side Panels snugly fitting into the Mortises in Base Stand(C) as picture 1 Align the Mouting Positions of the Left Side Panel(C) with those on the Front Panel(B). Insert Medium Screws(K) through the Mounting Positions and affix using Allen Key(M) and slightly tighten the Screws as picture 2 Repeat the same process with the Right Side Panel(D). DO NOT overtighten the Screws.
PAGE 5
Step 5 Place the Cabinet as shown in the above picture.. Align and insert the Long Screws(I) through the Mounting Positions and affix to Base Stand(G) by using Allen Key(M). Step 6 Pic. 3 Carefully stand the Cabinet up. Put the Table Top(A) onto the Cabinet. Push Table Top(A) forward until the Mounting Positions are aligned. To affix the Table Top(A) insert the Short Screws(L) through the Mounting Positions of the Cabinet and Table Top(A) with Allen Key(M).
PAGE 6
Step 7 E Prefitted Dowel at prefitted support bar Align and insert the Shelves(E) with Mounting Position : prefitted Dowel at preffitted support bars on the side of the Cabinet. Step 8 Align and insert the Bottle Holder (H) on the Base Stand (G). Insert the Short Screws (L) through the mounting position and affix the Tray (H) by using Allen Key (M).
PAGE 7
Step 9 Proceed to fully tighten all Screws, in a sequential manner. Ensure that all Screws are securely tightened. Your Bar Cabinet is ready for use.
PAGE 8
OUTDOOR Noble House Home Furnishings LLC Page 8 of 8