Caution : You must read this before you proceed Ottoman Label Description QTY A Seat 1 B Leg 2 C Seat Cushion 1 Description QTY ① Bolt (M6*10MM) 5 ② Bolt (M6*25MM) 5 ③ Allen Key 1 Label Picture Picture Noble house Home Furnishings LLC Page 1 OF 6
Before Beginnin g Assembly : Overview Seat Cushion(C) Leg(B) Seat(A) FRONT FACING This Ottoman has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Ottoman parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 A Open the carton and place all the parts onto a clean, non-marring surface.,Take out the silders in the four ends of the Seat(A ) using Allen Key( ③). Step 2 A B setp2.2 setp2.1 ③ ② ③ ① Place the seat(A) facedown. Step2.1:Attach Leg(B) to Seat Panel(A) using Bolts(②) with Allen Key(③) as shown above Step2.2:Attach Leg(B) to Seat Panel(A) using Bolts(①) with Allen Key(③) as shown above Do not fully tighten the Bolts.
Step 3 B B A A setp3.2 setp3.1 ③ ③ ① ② Step3.1:Attach Leg(B) to Seat(A) using Bolts(②) with Allen Key(③) as shown above Step3.2:Attach Leg(B) to Seat(A) using Bolts(①) with Allen Key(③) as shown above Do not fully tighten the Bolts.
Step 4 C Stand the Ottoman up. Put Seat Cushion(C) on the Ottoman Your Ottoman is ready for use. Place the Ottoman on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and carefully sit onto the Ottoman This will help to align all parts at all joints.Then get off the Ottoman, and in a sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one.
Noble house Home Furnishings LLC Page 6 OF 6