Instructions / Assembly

Label Picture Description QTY
A
Top Tree Section
(larger Trees include one or
more Sections)
1
B Metal Tree Stand 1
Assembly Steps
Step2
Each carton container one Top Tree Section(A) or one Bottom Tree Section(larger trees
include one or more Middle Sections) and a Metal Tree Stand (B).
Unfold a Metal Stand(B) and insert the Eye Bolt. Remove packing material from ends of
Poles. Put Bottom Section Pole into Tree stand making sure it is seated properly (Figure 1).
Tighten Eye Bolt.
WARNING: Using excessive force to assemble base may cause breakage.
Insert the Top Tree Section into the Green Plastic opening of the lower Tree assembly. This
is the "Pole Cap" which keeps Tree top section securely in place(Figure 3). For larger Trees
with middle section carefully insert middle section pole(s) into bottom section pole (Figure 4)
as instructed in SPECIAL NOTE ABOUT GLANT TREES below.
Then insert Top Section into Pole Cap.
Optional:You may want to lubricate Middle Section Pole ends prior to assembly. This will
make Sections easier to separate when disassembling for storage.
HINGED TREES: Branches should fall into place during assembly. If any branches remain
upright, gently lower them into proper position(Figure 5). Each Branch must be shaped to a
natural position by spreading out the left and right tips away from the center tip. Continue to
lower branches on upper section(s) in the same manner making sure not to place undue
pressure on the brackets.
Part List
Step1
A
B
Page 2 OF 5