Instructions / Assembly

ManualsBrandsNoble House ManualsOutdoor CouchesHampton Natural Stained 1-Piece Wood Outdoor Couch

Assembly Instructions

Caution: You must read this before you proceed

3 SEATER CHAIR

CAUTION: This 3 SEATER CHAIR is NOT a TOY.

Keep your child / children at bay during the assembly process of assembly.

For turning the 3 Seater Chair and to prevent damage to the 3 Seater Chair, 02

persons may be needed to execute this action

Noble House Home Furnishings LLC

Summary of content (9 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed 3 SEATER CHAIR CAUTION: This 3 SEATER CHAIR is NOT a TOY. Keep your child / children at bay during the assembly process of assembly.
PAGE 2
Parts List Label Picture Description QTY A Backrest Panel 1 B Seat Panel 1 C Right Leg Panel (with Leveler) 1 D Left Leg Panel (with Leveler) 1 E Leg Support Bar 1 Noble House Home Furnishings LLC 2
PAGE 3
Hardware Label Picture Description QTY ① Bolt (M8x55mm) 7 ② Bolt (M8x25mm) 7 ③ Screw (M7x60 mm) 3 ④ Flat Washer (M8.
PAGE 4
Assembly Steps Overview Right Leg Panel (C) Backrest Panel (A) Seat Panel (B) Left Leg Panel (D) Leg Support Bar (E) FRONT FACING This 3 Seater Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the 3 Seater parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 5
Step 2 2.2 A D 2.1 C Pre-fixed Iron Dowel Lay down the Backrest Panel (A) on a clean, non-marring surface. Step 2.1: With assistance from your adult partners, position housing of Left Leg Panel (D) into pre-fixed iron dowel on Backrest Panel (A) as picture above. Step 2.2: Secure Left Leg Panel (D) to Backrest Panel (A) by using Bolt (①) with Allen Key (⑤) Repeat the same process to attach Right Leg Panel (C) to Backrest Panel (A) Do not fully tighten the Bolts.
PAGE 6
Step 3 C D A B With assistance from your adult partner, put the Seat Panel (B) onto the preassembled in step 2. Repeat same process in step 2.1 and 2.2 to Secure Right Leg Panel (C) and Left Leg Panel (D) to Seat Panel (B).
PAGE 7
Step 4 B A Secure Seat Panel (B) to Back Panel (A) using Bolt (②) & Washer (④) with Allen key (⑤) Do not fully tighten the Bolts. Step 5 C E D Insert Leg Support Bar ( to Right Leg Panel (C) and Left Leg Panel (D) using Screw (③) with Allen key (⑤) as shown above. Note: You might need to apply a little pressure to the Leg Panels pushing outwards slightly to insert the Leg Support Bar (E). Do not fully tighten the Screws.
PAGE 8
Step 6 Adjust Pre-installed Levellers height for balance With assistance from your adult partners, turn the Chair back to normal flat ground. Place the Chair on a LEVEL surface. Inspect it and make sure all parts are adequately connected. Gently and gracefully, sit onto the Chair. This pressure will help to align all the parts at all joint areas. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts and Screws in a sequential manner, until evenly secured.
PAGE 9
Noble House Home Furnishings LLC 9