Instructions / Assembly

Step 2
Step 3
Make sure that the Chair Seat and the Chair Leg Base is fully and
firmly attached together as one complete piece.
Turn Barstool rightside up.
Adjust the pre-installed Leveller until the Barstool is level with the
ground.
Then, proceed to tighten all Bolts and Nuts.
Your Barstool is ready for use.
Caution: This Barstool can only be used on a flat, level surface.
Place Chair Seat(A) upside down.
Align the mountings on the bottom of the Chair Seat(A) with the
mountings on the Chair Leg Base(B).
Then, attach the Chair Leg Base(B) to the Chair Seat(A) with
Bolts(①),Washers(②) and Springs Washers(③) using the
Spanner(④).
Do this in a sequential manner.
Do not over tighten yet.
Adjust height
for balance
Adjust low for
balance
Noble house Home Furnishings LLC 4 OF 5