Instructions / Assembly

ManualsBrandsNoble House ManualsOutdoor Lounge ChairsCadence Mixed Black 2-Piece Wicker Patio Deep Seating Set with Dark Grey Cushions

No Picture Parts Qty No Picture Parts Qty

Assembly Instructions

List parts of Club Chair

A Chair Back 1 G Bolt Dia.M6*35mm(L) 4

B Left Arm 1 H Bolt Dia.M6*40mm(L) 8

C Right Arm 1 I

Flat washer

Ø16*1.2mm(TH)

D Chair Seat 1 J

Spring washer

Ø16*2mm(TH)

E Leveler 4 K Allen key 1

Plastic cap (to cover

bolt heads

)

Assembly Instructions:

Assembly

Instructions:

Step 1 and 2 : Open the carton and place all the parts onto a clean and soft

surface,compare the real parts with the above list to make sure each part is

available,place the left arm (B) with its inside facing up onto the soft surface,put the

chair back(A)against the left arm(B) with the chair back(A)

s upper metal rod inserted

Step 3 and 4 : Place the chair seat (D)with its short side facing front between the

left arm(B) and chair back(A),attach the chair seat(D)to the left arm(B) on their

sides with flat washer(I)+spring washer(J)+bolt(G), attach the chair seat(D) to the

chair back(A) on the rear side with flat washer(I)+spring washer(J)+bolt(H) use an

chair

back(A)against

the

left

arm(B)

with

the

chair

back(A) s

upper

metal

rod

inserted

into the top rear end of left arm(B), attach them together with flat washer(I)+spring

washer(J)+bolt(H),use an Allen key(K) to tighten them, but not completely.

chair

back(A)

the

rear

side

with

flat

washer(I)+spring

washer(J)+bolt(H)

use

Allen key(K) to tighten them ,but not completely

Step 5,6 and 7 : Place the right arm (C ) againt the chair back(A) and chair seat(D),

insert the chair back(A)

s upper metal rod into the top rear end of right arm( C ) attach

Step 8 and 9 : Turn the leveler(E)into the chair body,tighten all bolts completely and

put the plastic cap(F)to cover the bolt heads adjust the leveler(E)to ensure good

insert

the

chair

back(A) s

upper

metal

rod

into

the

top

rear

end

right

arm(

)

attach

the chair seat(D ) to the right arm(C ) with flat washer(I)+spring

washer(J)+bolt(G),attach the chair back (A) to the righ arm( C ) with flat washer((I) +

spring washer(J)+bolt(H), use an Allen key(K) to tighten them ,but not completely

put

the

plastic

cap(F)to

cover

the

bolt

heads

adjust

the

leveler(E)to

ensure

good

stability, it is ready for use.