Assembly Instructions Caution: You must read this before you proceed Stool Picture Part List Label Picture Description QTY A Seat Panel 1 B Stool Legs 1 C Seat Cushion 1 Noble House Home Furnishings LLC Page 1 OF 5
Hardware Label Picture Description QTY ① Bolt (M6X20mm) 5 ② Washer 5 ③ Cap 5 ④ Allen Key 1 Assembly Preparation Before Beginning Assembly: Noble House Home Furnishings LLC Page 2 OF 5
Assembly Steps Overview Seat Cushion (C) Seat Panel(A) Stool Legs (B) FRONT FACING This Stool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the the Stool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 3 Stand the Stool up. Exert pressure floorwards, onto the chair with both your hands. This pressure will help the Legs and chair Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one. If there are still wobbles, loosen the Bolts and excute the same above process.
Step 6 Your Stool is ready for use. This Stool can only be used on a flat and level surface.