Instructions / Assembly

Label Picture Description QTY

A Seat 1

B Chair Legs 1

C Seat Cushion 1

Label Picture Description QTY

①

Bolt

(M6X35mm)

② Washer 5

③ Spring Washer 5

④ Cap 5

⑤ Allen Key 1

Assembly Instructions

Caution: You must read this before you proceed

Chair

Picture

Part List

Hardware

Noble House Home Furnishings LLC Page 1 OF 4

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Chair Picture Part List Label Picture Description QTY A Seat 1 B Chair Legs 1 C Seat Cushion 1 Description QTY ① Bolt (M6X35mm) 5 ② Washer 5 ③ Spring Washer 5 ④ Cap 5 ⑤ Allen Key 1 Hardware Label Picture Noble House Home Furnishings LLC Page 1 OF 4
PAGE 2
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Seat (A) Seat Cushion (C) Chair Legs (B) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
PAGE 3
Step 3 Exert pressure floorwards, onto the Chair with both your hands. This pressure will help the Legs and Seat reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured. When tightening the Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one. If there are still wobbles, loosen the Bolts and excute the same above process. Step 4 Turn over the Chair.
PAGE 4
Noble House Home Furnishings LLC Page 4 OF 4