MANUEL INSTRUCTIONS DU PROPRIÉTAIRE Foyer au Gaz Manuel & Guide de I'Utilisateur Noble house Home Furnishings LLC
LIMITATION DE GARANTIE ET RESPONSABILITÉ AVERTISSEMENT: Veuillez Lire cette Limitation de Garantie et Responsabilité avant d'Utiliser ce Produit. Si les Conditions ne Sont pas Acceptable, Retourner le Produit Non Ouvert Immédiatement, le Prix d'Achat Sera Remboursé. Il est impossible d'éliminer tous les risques associés avec l'utilisation de ce produit.
Part A. RENSEIGNEMENTS SUR LA SÉCURITÉ Avant d’assembler ou d’utiliser cette unité, veuillez lire avec sol tout ce gilde. L'omission de ce processus peut entraîner un Incendie, une explosion, une blessure corporelle ou la mort.
* NE remplissez PAS la bouteille 4 un niveau supérieur système d'alimentation de la bouteille doit assurer le retrait de vapeur. « Cessez l'utilisation si une partie de la bouteille de propane est endommagée. La rouille et les bosses peuvent être dangereuses et doivent être inspectées par un fournisseur de gaz. * Ne brellez rien d'autre que les matériaux fournils pour ce foyer de Jardin.
+ Gardez I’ appareil propre et libre de matériaux combustibles , essence et autres vapeurs et liquides inflammables. + Si la flamme s’éteint lors du branlage, fermez la valve de gaz. Attendez 5 minutes avant de ria procédure initiale d’allumage. Quand une flamme se produit, maintenez enfoncé le bouton de commande pendant une minute. + N'ajoutez pas d’eau dans I'unité. N’utilisez pas I'unité sl une parte a été submergée dans I'eau.
« ll faut que les enfants et les adultes dolent avertis des dangers des surfaces chaudes et qu’ils so tiennent & une distance sécuritaire afin d’éviter les brisures ou l'inflammation des vêtements. « IL FAUT surveiller les Jeunes enfants de prés quand lis sont a proximité de appareil. « On ne doit pas suspendre des vêtements ou tout autre matériel inflammable, ni les placer sur ou prés de Appareiller.
Part B PANNEAU DE CONTRÔLE DE L'ALLUMEUR Ci-dessous est présenté I'affichage visuelle du Tableau Opération comme vous pouvez trouver sur votre Foyer. Veuillez lire avec attention avant de L’utiliser.
Guide de I'Utilisateur: Pièces et Accessoires du Régulateur, Part C Valve de Charge de Cylindre et Étapes pour Connecter la Bouteilles au Foyer. Cette paragraphe de l'information sur la Sécurité contient les informations qui: 1) vous présente le régulateur ( pré-connecté au Foyer) 2) la Valve d’Alimentation de la Bouteille de gaz et les valves correspondantes. Il y a des Foyers qui possèdent la Bouteille de gaz a Intérieur ou a I'extérieur.
Part D Guide de I'Utilisateur : Placer la Bouteille de Gaz dans le Foyer. Le Foyer a une porte. Ouvrir la Porte Dedans, vous allez vor un support en métal avec un vis ailée/écrou pré-attaché. Commencez a dévisser la vis ailée. Insérer la Bouteille de Gaz comme indiqué la flache noir. Placer doucement et confortablement sur le Support en métal. Posltlonner la vis allées en place. Tourner la Vis a fond dans I'écrou. La bouteille est maintenant sécurisée en place. Part E.
FOYER: INTRODUCTION DES PIECES Part 092 §5.
Le tableau suivant présente tous les places montrées au-dessus.
rt Manuel de Utilisable p piécette ot Accessoires d Foie Le tableau ci-dessous est une gilde 2 différentes places et accessoires pour compléter la Foyer. |Avant de commencer & assembler ce produit, assurez-vous d’avoir toutes les places. ‘Comparer les places que vous avez avec la liste. Si une ou plusieurs pi¢ces est manquée ou endommagé, NE PAS essayer d'assembler le produit.
ÉTAPES D'ASSEMBLAGE 1. Vérifier si le Bouton de Commande du système d'alimentation de gaz (13) Contre-sol Snob {13) for the gas suppl myste is turnes to the “OFF” position fore instar any assemble. 3 2.Fixez lo panneau (F) sur le support en métal (J) & l'aide de 4 boulons (D) avec ¢lé Alken Les pls ne serrant pas complètement. {Taie 3. Fixez le panneau (E), le panneau (G) et le panneau {H) avec le panneau {F) ensemble a l'aide de 12 boulons avec une clé Alken Les pls ne serrent pas complètement. 4.
5.Fixer le levier d'art (M} avec le panneau (E) et le panneau (H) ensemble 4 'aide de 2 boulons avec une clé Alken Les pls ne serrent pas complètement. 6.Attachez le levier d’airée (N) avec le levier d’arrêt (M) et le support métallique (J) ensemble a L’aide de 2 boulons {D) avec clé Alken Les pls ne serrant pas complètement. 7. Retournez d'abord la base en métal, puis alignez-la sur le dessus de la table (D).
ÉTAPE 4 SOUPAPE BE DÉCHARGE ROBINET BE BOUTEILLE JL ton ROBINET PURGEUR router ‘dans le 5 gène Horaire open. reformer crouille SERRAGE NOIR tonnelier dans le sens horaire pour cacarder N RÉGULATEUR fie] ~ EY 4. Tournez la Valve de Cylindre (21 ) sur la bouteille dans le sens horaire & la position pour éteindre I'alimentation de gaz. |Attachez le régulateur réassemblé (12/19) sur le Foyer & la valve de cylindre (21) en tournant I'écrou de serrage noir (20) dans le sens horaire.
STEP 7 Selon votre préférence, vous pouvez verser les pierres de lave a travers I'anneau de Brûleur. La Garde NE DOIT PAS ÊTRE BLOQUE. Consultez la guide ci-dessous. Note: Ne mettez plus de 1/4 po d’épaisseur de pierres de lave sur le trou de Brûleur. Valsant cela va faire étouffer la flamme. Noto: Ne placez pas plus de 6KG de pierre de lave sur les orifices du bruleur.
[Avant de faire un essai d’étanchéité, assurez-vous de: 1.) NE PAS presser I'amorceur. 2.) être dans un grand espace extérieur. Raccordez la bouteille de gaz propane au régulateur (12/19) et tournez la valve {22) de I'unité a la position ‘OFF’ Brossez une solution d'eau savonneuse sur tous les raccords. Ouvrez I'alimentation en gaz; sl des bulles se produisent su un raccord quelconque, Il y a possiblement une fuite.
Avant chaque utilisation, inspectez le Tuyau d’alimentation. Remplacer le tuyau (12) s'il y a des signes d’ usure ou d’abrasion se présentent. Avant d'allumer le Foyer, veuillez suivre les étapes suivantes : 1. Assurez-vous que le bouton de commande (13) est sur la position ‘OFF’ (arriéré. 2. Ouvrer la porte (07) et ouvrez lentement la valve (22) de la bouteille de gaz propane en tournant le bouton {13) dans le sens antihoraire. 3. Fermer la Porte (07) sur le Cadre Principal (06) du Foyer. 4.
Part L. INFORMATION SUR LA SÉCURITÉ : POUR ÉTEINDRE VOTRE FOYER Pour éteindre le foyer, veuillez suivre les étapes suivantes: 1. Tourner le Bouton de Commande dans le sens horaire a la position "OFF". 2. Fermer la valve bouteille de gaz propane sl vous n’avez pas I'Intentlon de L’utiliser pendant une période prolongée. Part M. ENTRETIEN FOYER AU GAZ « Avant d’effectuer des travaux d’entretien, assurez-vous que le bouton de commande (13) est en position "OFF" et détachez toujours la bouteille de gaz propane.
Part N. ENTRETIEN : ENTRETIEN DE LA SURFACE + Notre matériau a été scellé avec un traitement pour empêcher les taches et Absorption de 'l’humidité, et pour une longévité de ce produit, il exige I'entretien approprié pour assurer I'intégrité de la surface. « Veuillez trouver cl-dessus des recommandations pour Entretaille de votre surface de Foyer pour Joule d’ années d'usage: « Nettoyez immédiatement tout déversement pour empêcher une tache permanente ou des dommages a la surface.
Part O. DÉPANNAGE Un gilde simple est présenté cl-dessous avec des questions fréquemment problématiques fré éloquemment arrivés. Veuillez lire avec attention et serre-livres correctement. $1 vous avez une doute, appelez un Service de Technicien Qualifié ou les Pompiers.
Part P. GARANTIE La garante du fabricant sera annulée par le fabricant, et le fabricant décline toute responsabilité pour les actions suivantes du client/propriétaire : Modification de l'unité et (ou) de ses composants, y compris le système d’alimentation en gaz. The propre étaie devrait contacter le fournisseur local et une personne de service qualité pour remplacer ces pinces. + Emploi d'un composant non fabriqué ou approuvé par le fabricant.