Caution : You should read this carefully before you proceed Barstool Label Picture Description QTY A Backrest 1 B Left Armrest 1 C Right Armrest 1 D Foot Rest 1 E Seat Panel 1 Noble House Home Furnishings LLC Page 1 OF 8
Label Picture Description QTY ① Allen Key 1 ② Bolt (M6*65MM) 3 ③ Bolt (M6*40MM) 9 ④ Bolt (M6*20MM) 9 ⑤ Bolt Cap 11 ⑥ Washer 19 Before Beginning Assembly: Noble House Home Furnishings LLC Page 2 OF 8
FRONT FACING This Barstool has multiple parts and may require up to 45minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Place the Backrest (A) and the Seat Panel (E) on a clean, flat surface. Use bolts (3) and washers ( 6) to connect the Seat Panel (E) to the Backrest (A).
Step 2 Place the Left Armrest (B) on a clean, flat surface. Use bolts( 3 )and washers( 6) to connect the Left Armrest (B) to the Seat Panel (E). Note: Do not use the Allen Key (1) to tighten the bolts completely until all parts are assembled. Step 3 Place the Right Armrest (C) on a clean, flat surface. Use bolts（3）and washers ( 6） to connect the Right Armrest (C) to the Seat Panel (E). Note: Do not use the Allen Key (1) to tighten the bolts completely until all parts are assembled.
Step 4 Place the Left Armrest (B) on a clean, flat surface. Use bolts（4）and washers (6) to connect the Foot Rest (D) to the Left Armrest (B) , the Right Armrest (C) and the Backrest (A). Note: Do not use the Allen Key (1) to tighten the bolts completely until all parts are assembled. Step 5 Use bolts (2) and washers (6) to connect the back end of the Left Armrest (B) to the Backrest (A). Then use bolts (2) and washers ( 6) to connect the back end of the Right Armrest (C) to the Backrest (A).
Step 6 Place the barstool on a LEVEL SURFACE to check for wobbles. If it wobbles lift the barstool to some 20cm to 30cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the barstool freely and vertically with the four legs, hitting the ground, all at the same time. This Drop Test will help to ensure that all the bolts and gaps reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles are found, slowly and steadily turn the barstool upside down.
Step 7 Cover all bolts with Bolt Caps (5). Step 8 Your Barstool is ready for use.
Noble House Home Furnishings LLC Page 8 OF 8
