Instructions / Assembly

ManualsBrandsNoble House ManualsOutdoorsTasmania Dark Grey 49.5 in. 2-Person Wood Porch Swing

Assembly Instructions

Caution: You must read this before you proceed

Swing

Noble House Home Furnishings LLC

CAUTION: This Swing is NOT a TOY.

Keep your child/children at bay during the assembly process.

Whenever lifting or moving the Swing and to prevent damage to the Swing, two adults

may be needed to execute these actions.

Noble House Home Furnishings LLC

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Swing CAUTION: This Swing is NOT a TOY. Keep your child/children at bay during the assembly process. Whenever lifting or moving the Swing and to prevent damage to the Swing, two adults may be needed to execute these actions.
PAGE 2
Part List Label Picture Description QTY A Backrest Panel 1 B Seat Panel 1 C Left Arm Panel 1 D Right Arm Panel 1 Description QTY ① Screw (M6x90mm) 4 ② Bolt (M6x35mm) 3 ③ Sleeve Nut (M6x35mm) 3 ④ Lock Nut (M9) 5 ⑤ Eye Bolt (Ø9x60mm) 4 ⑥ Chain (Ø5x2440mm) 4 ⑦ Carabiner (M8) 6 ⑧ Washer (Ø10/20x2mm) 5 ⑨ Wrench (Ø17x2mm) 1 ⑩ Allen Key 2 Hardware Label Picture Noble House Home Furnishings LLC 2
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview This Swing has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Swing, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 B A With assistance from your adult partner, attach Backrest Panel(A) to Seat Panel(B) by using Screws(①) with Allen Key(⑩) as shown above. Do not fully tighten the Screws. Step 3 Insert the tenons of the Seat Panel(B) into the mortises of Left Arm Panel(C) and Right Arm Panel(D), then attach using Lock Nuts(④), Washers(⑧), and Eye Bolts(⑤), with Wrench(⑨) as shown above. Do not fully tighten the Bolts.
PAGE 5
Step 4 Attach Backrest Panel(A) to Left Arm Panel(C) and Right Arm Panel(D) using Bolts(②) and Sleeve Nuts(③) ③ with Allen Keys(⑩) ⑩ as shown above. Do not fully tighten the Bolts. Step 5 Step 5.1 Step 5.2 5.1) Unscrew the connection on Carabiner(⑦), then loop the Chain(⑥) onto the Carabiner(⑦), and screw the connection shut.
PAGE 6
Step 6 Carefully sit onto the Swing. This pressure will help the swing reach full alignment at all joints. In a sequential manner, gradually tighten all Bolts and Nuts until evenly secured. Your Swing is ready for use. This Swing can only be used on a flat, level surface.