Assembly Instructions Caution: You must read this before you proceed Please look in the velcro pouch for hardware packs and legs CHAISE Noble House Home Furnishings LLC Page 1 OF 9
Part List Label Picture Description QTY A Seat Base 1 B Backrest 1 C Pillow 1 D Seat Cushion 1 E Left Armrest 1 F Right Armrest 1 G Leg 4 Noble House Home Furnishings LLC Page 2 OF 9
Hardware List Label Picture Description QTY ① Plastic Washer 7 ② Bolt(M8*55) 11 ③ Flat Washer 11 ④ Spring Washer 11 ⑤ Allen Key 1 Assembly Preparation Before Beginning Assembly: Noble House Home Furnishings LLC Page 3 OF 9
Assembly Steps Right Armrest(F) Backrest(B) Left Armrest(E) Pillow(C) Seat Cushion(D) Seat Base(A) Leg(G) FRONT FACING This Chaise has multiple parts and may require up to 60 minutes to assemble. To give you an overview of the Chaise parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Open the carton and place all the parts on a clean, non-marring surface. Position Seat Base(A) as shown.Attach the Right Armrest(F) to Seat Base(A),using Bolt(②),Spring Washer(④),Flat Washer(③) and turning clockwise by hand. DO NOT over tighten. Step 2 Left Armrest(E) Seat Base(A) Right Armrest(F) Attach the Left Armrest(E) to Seat Base(A) using Bolt(②),Spring Washer(④),Flat Washer(③) and turning clockwise by hand . DO NOT over tighten.
Step 3 Backrest(B) Left Armrest(E) Right Armrest(F) Seat Base(A) Left Armrest(E) Right Armrest(F) Seat Base(A) Standing behind the Seat Base(A) while holding Backrest(B).Hang on the hook of Backrest(B) onto the Preserved bolt of Left Armrest(E) as shown above,make sure two hooks are both on top of Preserved bolt. Repeat the same step to install the another side onto the hook of Right Armrest(F).
Step 4 Left Armrest(E) Right Armrest(F) Seat Base(A) Positon the Seat Base(A) as shown above. Attach the Backrest(B) to the Seat Base(A) using Bolt(②), Spring Wash(④),Flat Washer(③),with Allen Key(⑤) turning clockwise until tight. Tighten all Bolt(②) in the Right Armrest(F) and Left Armrest(E) with Allen Key(⑤).
Install the Leg(G) into the bottom of Seat Base(A) by placing Plastic Washer(①) on the threaded stem. Then insert threaded stem into the threaded mounting postion at the bottom of Seat Base(A).Tighten by turning the Leg clockwise. Repeat the same step to install remaining Legs. Note: The use of Plastic Washer(①) are OPTIONAL and are especially useful to help alleviate slight wobbles. Some Legs may need more than one whilst some legs may not need any.
Noble House Home Furnishings LLC Page 9 OF 9