Instructions / Assembly

Label Picture Description QTY

A Top Tree Section 1

B Metal Tree Base 1

CAUTION: IMPORTANT SAFETY INSTRUCTIONS

● For indoor use only.

● Keep product away from water and damp environments.

● Do not mount or place near gas or electric heaters, fireplaces, candles or

other similar sources of heat.

● Check the tree, its plug, wiring and components regularly. If any damage is

evident to any of the electrical elements, stop using immediately.

● When positioning the branches ensure that the lights on the tree are

switched off.

● Before using, make sure that all electrical connections are securely fitted.

● Do not touch the light source during operation!

● If any damage occurs to the electrical components, please stop to use

and refer to a qualified electrical professional for advice.

● Unplug the product when leaving the house, when retiring for the night, or

if leaving it unattended.

● The tree is only designed to be use with the supplied plug, please do not

use any other substituted plug type.

● Maintenance/cleaning of the lights is limited to the surface exterior, using

a dry cloth only.

● CAUTION: This is an electrical product-not a toy! To avoid risk of fire,

burns, personal injury and electrical shock, it should not be played with or

placed where small children can reach it.

Assembly Instructions

Caution : You must read this before you proceed

ARTIFICIAL CHRISTMAS TREE

Part List

Noble house Home Furnishings LLC

Page 1 OF 3

PAGE 1
Assembly Instructions Caution : You must read this before you proceed ARTIFICIAL CHRISTMAS TREE CAUTION: IMPORTANT SAFETY INSTRUCTIONS ● For indoor use only. ● Keep product away from water and damp environments. ● Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat. ● Check the tree, its plug, wiring and components regularly. If any damage is evident to any of the electrical elements, stop using immediately.
PAGE 2
Assembly Steps Each carton contains one Top Tree Section(A) and one Metal Tree Base(B). Install the Metal Tree Base(B) at the bottom of the Top Tree Section(A) by inserting the threaded stem into the threaded mounting postion on theTop Tree Section(A). Tighten by turning the Top Tree Section(A) clockwise. WARNING: Using excessive force to assemble the base may cause breakage. Shaping Instructions Shaping the Tree Branches is the last step of assembly.
PAGE 3
Pre-Lit Trees Fig.4 Fig.5 Some tree styles will have a single extension cord that will run from the trunk of the tree and out to the electrical outlet. ALL light strings will plug into this single cord(Figure 4). When you Plug in the power, the tree will light up (Figure 5). Storage Gently press the tips back against the center Branch. Raise all Branches to their original upright position taking care not to place undue pressure on the attached ends of the branches.