User's Guide

Consult the dealer or an experienced radio/TV techni

cian for help.

SAR Information Statement

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured

not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the

Federal Communications Commission of the U.S. Government. These limits are part of

comprehensive guidelines and establish permitted levels of RF energy for the general

population. The guidelines are based on standards that were developed by independent

scientific organizations through periodic and thorough evaluation of scientific studies. The

standards include a substantial safety margin designed to assure the safety of all persons,

regardless of age and health. The exposure standard for wireless mobile phones employs a

unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by

the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its

highest certified power level in all tested frequency bands. Although the SAR is determined

at the highest certified power level, the actual SAR level of the phone while operating can

be well below the maximum value. This is because the phone is designed to operate at

multiple power levels so as to use only the power required to reach the network. In general,

the closer you are to a wireless base station antenna, the lower the power output. Before a

phone model is available for sale to the public, it must be tested and certified to the FCC that

it does not exceed the limit established by the government adopted requirement for safe

exposure. The tests are performed in positions and locations (e.g., at the ear and worn on

the body) as required by the FCC for each model. The highest SAR value for this model

phone when tested for use at the ear is 0.691W/Kg and when worn on the body, as

scribed in this user guide, is 1.100W/Kg(Body-worn measurements differ among phone

models, depending upon available accessories and FCC requirements). While there may be

differences between the SAR levels of various phones and at various positions, they all meet

the government requirement for safe exposure. The FCC has granted an Equipment

Authorization for this model phone with all reported SAR levels evaluated as in compliance

with the FCC RFexposure guidelines. SAR information on this model phone is on file with the

FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid

after searching on

FCC ID: 2AS47-NB3G20 Additional information on Specific Absorption Rates

(SAR) can

be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at

http://www.wow-com.com. * In the United States and Canada, the SAR limit for mobile

phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The

standard incorporates a sub-stantial margin of safety to give additional protection for the

public and to account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure

requirements, a minimum separation distance of 15mm must be maintained between the

user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and

similar accessories used by this device should not contain any metallic components.

Body-worn accessories that do not meet these requirements may not comply with RF

exposure requirements and should be avoided. Use only the supplied or an approved antenna