Operation Manual

USER CONTROLS

Computer Mode

IMAGE-I

(COMPUTER MODE)

Brightness

Adjusting the brightness of the image.

■ Press the key to darken the image.

■ Press the key to lighten the image.

Contrast

The contrast controls the degree of difference between the lightest and

darkest parts of the picture. Adjusting the contrast changes the amount of

black and white in the image.

■ Press the key to decrease the contrast.

■ Press the key to increase the contrast.

Colour Temperature

Adjust the colour temperature. The range is from “0”to “4” The factory

default is “2”. With the higher temperature, the screen looks colder; with the

lower temperature, the screen looks warmer.

Zoom

■

Press the to magnify an image up to a factor of eight times on the

projection screen.

■ Press the to Diminish the zoom in image. Lowest available setting is 1/2-size.

Keystone (Keystone Correction)

Adjust image distortion caused by tilting projection. (±16 degrees)

White Segment

Use the white segment control to set the white peaking level of the DMD

chip.”0” stands for minimal peaking, and “10” stands for maximum peaking.

If you prefer a stronger image, adjust toward the minimum setting. For a

smooth and more natural image, adjust toward the minimum setting.