Manual

Noby-220i
ii
iR2 Installation Manual Page 11 Software Revision1-0
- - -
LED Indications:
A steady green LED indicates that this panel is i
ii
interlink enabled.
A steady red LED indicates that this panel is i
ii
interlink disabled i.e. no address programmed.
The pulsing red LED indicates the programmed address number 1 to 8 of this panel.
The 8 yellow pushbutton LEDs indicate the detection of all connected panels on the i
ii
interlink bus, with this
panel's LED rapidly flashing.
Procedure:
• Enter the i
ii
i nterlink Code .
• Allow 5 seconds for scanning - the 8 yellow pushbutton LEDs cycle around.
• Press to seek the next available address - indicated by a rapid flashing pushbutton LED.
- OR -
• Press to clear the address and disable this panel's i
ii
interlink functionality.
• Press to accept OR press to quit without updating the option.
• Allow 8 seconds for the system to stabilise before proceeding with other panel operations.
Note: The panel automatically kicks back to normal standby User Mode after 60s if left unattended.
Removing a Noby-220i
ii
iR2 panel from the i
ii
interlink bus
A panel may be effectively switched offline by clearing its address as described in the above procedure.
1
2 2 2
1
2
Figure 4:
i
ii
i nterlink
Programming
LED Display